[Riff_Raff]

Look into Reid Racing Knuckles to move that steering even higher. Great post, thanks for sharing.
DM_W

Wasn't there a kit available with the brakes, spindles etc. to accompany the knuckles?

 

[Riff_Raff]

Looks good.

 

[Riff_Raff]

The Teraflex high lift kit for the Dana 44 has the tie rod below the axle. I would need to drill the driverside tapered hole to and put a tapered insert to flip the tie rod on top of the hub steering arm. At least the tie rod save the axle form scratches. I just have to bend it back into shape.

I take it that is your trackbar bracket on the left? Tell me more about it.

 

[Riff_Raff]

Most helpful, thanks!

I'm asking because I want to do the high steer also.

When I look at the top picture on page two I can see the bolt for the stabilizer bar.

Do you have a print for the bracket or did you design it as you went?
So you did away with the steering stabilizer too?

Thanks again!

 

[Riff_Raff]

More good info, thanks.

 

[Riff_Raff]

Thanks Ggg.

Well, my Reid knuckles arrived and the taper for the tie rod is set up to bottom mount just like 05ru's Terra knuckles.

As an added bonus the seller included the stud/nut kit for both knuckles to run the upper arms. I'm thinking if the upper arms can run TRE's, maybe I should just go that route rather than mess with drilling for a flip?