Jeep Wrangler Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
34 Posts
Discussion Starter #1
OK so i'm going to change my front axle actuator from vacuum to a cable lock kit. any thing i should know befor i start..
 

·
Internet Owner
Joined
·
9,510 Posts
Make sure your beer is cold?
It's a pretty straight forward installation. Just make sure the inside knob is mounted to a secure mount, not to plastic.
Also mke sure the cable does not get too close to the exhaust manifold and no sharp bends.
Be careful opening your beer you do not spill any.
That's about all.
Did you get the PosiLok brand cable? I have it and it never fails three years in.
 

·
Registered
Joined
·
34 Posts
Discussion Starter #3
LOL good thinking (1) cold beer...

No i didn't bought "Rugged Ridge" It had four comments and they all good
 

·
Internet Owner
Joined
·
9,510 Posts
Only one beer? It is a two beer job if you are alone, four if you have help.
I think the Rugged Ridge one is identical.
Just follow the directions. Nothing to it.
 

·
Registered
Joined
·
5 Posts
i have the Ox locker with the cable, make sure you install the cable away from pinch point to keep from damaging it. if you can put your rig on a ramp to check clearanceissues. Rugged ridge is a good product.
 
1 - 6 of 6 Posts
Top