Jeep Wrangler Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #4 ·
I haven't tried the throttle body yet. I have replaced the fuel filter, TPS, Idle sensor and the fuel pressure sensor, spark plugs, wires, distributor and rotar. I also added some Lucus injector cleaner and about 4 Gal of 93 octane. The spark plugs only have about 500 miles on them. Also, sometimes when I get it to start I can give it gas but it sounds like it is getting too much air, but more so than not, if I try and give it gas after it starts it dies immediately. I haven't pulled any codes on it and don't even know how, can anyone explain that to me? Thanks in advance.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top