Problems after timing belt replacement - Jeep Wrangler Forum


Go Back   Jeep Wrangler Forum > General Wrangler Discussions > Electrical / Audio / Communication

WranglerBoard.com is the premier Jeep Wrangler Forum on the internet. Registered Users do not see the above ads.
Reply
 
LinkBack Thread Tools
Old 12-11-2016, 12:41 PM   #1
cyndibriggs2004
Junior Member
Feedback Score: 0 reviews
 
Join Date Dec 2016
Posts: 1
Default Problems after timing belt replacement

Replace timing belt on 2004 Jeep Wrangler 2.4 (4 cylinder) 74,000 miles
Hooked it up to diagnostic: replaced throttle/pedal position sensor, PCV Valve and Idle Air Control sensor.
Had some oil in Air Idle sensor after hook up and before we installed PCV AND THROTTLE/PEDAL SENSOR. Cleaned it out with electronic cleaner.
Problem: Jepp runs well but stalls at every intersection. Any advice?
cyndibriggs2004 is offline   Reply With Quote
Sponsored Links
Advertisement
 
Reply

Thread Tools



All times are GMT. The time now is 01:58 PM.


Powered by vBulletin
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.